Setting up the BBPOS WisePOS E:
After unboxing your BBPOS WisePOS E, follow these steps to get everything setup:
Remove the battery cover
It is suggested to use something that won’t damage it, then lift up on the corner that has a small notch in the lower left when looking at it from behind. Keep lifting up until it comes off and be careful.
Place the battery inside and replace the battery cover
Power on by holding the power button on the right side for a few seconds
Plug in the charging cable, if needed, to power it up and charge the battery.
Connect to your network - WiFi or Ethernet (optional)
Connect to Wi-Fi
Wi-Fi with a Password is required
If you have an E-Dock, then plug in the ethernet cable on the underside and the power cord
Choose Language
Choose Country
The device will start updating software, this can take some time.
After the update is complete, a location needs to be created and the device needs to be registered.
Register the reader for DaySmart Vet:
Login to DaySmart Vet as an admin
Go to Settings
Click on Configuration, then choose New Device
Enter the Registration Code that is showing on the WisePOS E screen.
If you no longer have the registration code screen appearing, swipe from the left side of the WisePOS E screen to the right side.
Press Settings
Enter the default PIN 07139
Press on Generate pairing code
Enter a unique Display Name
This is optional, but it is recommended.
Press Save
It might show Registration Successful, applying updates.
If it doesn’t, then on the WisePOS E screen, press Back, then Back again.